Installation Guide (Petrol engine) How to apply Nano Fuel?
Locate the fuel line going to the engine (in between fuel filter and fuel injector). If there is an extra outer later on the fuel line, remove it. otherwise, wipe clean the fuel line with damp cloth. Then, put Qmax Nano Energy Saver (up to 4 pieces) on the fuel supply line, as close to the engine as possible by wrapping it tightly around the fuel pipe.
Installation Guide (Diesel engine) How to apply Nano Hose?
Locate the diesel supply hose in between Fuel filter and High pressure pump(or Diesel fuel pump). Replace the it with Qmax Nano Hose (Do Not cut it short). Use the manual pump found at Fuel filter and pump it for ½ minute. Start engine as usual.
Also, if further improvement is desired, each fuel line can applied with a Nano Fuel. Refer to the diagram on right. * installation on common-rail engine may be different
Copyright © QMAX | Koperasi Al-Najah (KL) Bhd