How to install Qmax Nano Fuel ? Qmax Nano Fuel can be easily installed (DIY) into all kinds of automobiles. First of all, life the engine hood to locate the position of the intake pipe in front of the carburetor / injector. Package the Qmax Nano Fuel around the intake pipe, followed by further coiling the Qmax Nano Fuel with pipe. If there is a factory rubber sheath attached on the surface layer of the intake pipe before installation, the rubber sheath need to be removed before application. No further dis-assembly is required during the installation process.

Following are few friendly reminders for installation process:  If the intake pipe wall is thicker than normal, the penetration of heat going through the wall will be rather inerricient. One of the quick solutions is by wrapping the entire exploring intake pipe with alumium foil before installing your Qmax Nano Fuel . This step helps the flow rate of heat exchange.

Make sure you have checked the status of your oil filter, oil level, along with periodic maintenance. Any previously accumulated carbon should be cleared before installation. After a successful application, the total exhaust will decrease, which also indicates that the engine has achieved a better efficiency of combustion.

If the engine rpm tested (shown by revolution counter) while idling appears to be higher after installation, this condition can be adjusted by tuning the bolt named “slow”.

The life cycle of Qmax Nano Fuel under normal conditions is over 250,000 km. So changing the Qmax Nano Fuel at every 250,000km will help to achieve optimum results.

Installation Guide (Petrol engine)

Locate the fuel line going to the engine (in between fuel filter and fuel injector). If there is an extra outer later on the fuel line, remove it. otherwise, wipe clean the fuel line with damp cloth. Then, put Qmax Nano Fuel (up to 4 pieces) on the fuel supply line, as close to the engine as possible by wrapping it tightly around the fuel pipe.

Installation Guide (Diesel engine)

Locate the diesel supply hose in between Fuel filter and High pressure pump(or Diesel fuel pump). Replace the it with Qmax Hose (Do Not cut it short). Use the manual pump found at Fuel filter and pump it for ½ minute. Start engine as usual. Also, if further improvement is desired, each fuel line can applied with a Nano Fuel. Refer to the diagram on right.

Application Qmax Nano Energy Saver (Clamp to)

Petrol Engine
Diesel Engine
Water Cooling System

Water Radiator hose (reduce water temperature) ..more details 

On Air-Conditioner System

Air-cond hose (improve cooling efficiency, extend gas/oil life, reduce engine load, lesser noise & vibration) ..more details

Spark Plug Coil Wire

Greater engine responsiveness ..more details

Battery Terminal

Battery Terminal(Reduce distortion or current noise,better response,improve sound quality as well) ..more details

Audio System

Audio amplifier power / RCA cable (improved sound quality) ..more details

Audio System

Audio amplifier power / RCA cable (improved sound quality) ..more details

Factory Machines (IRAN)
Factory Machines (IRAN)

CUSTOMER SUPPORT

  • FAQ
  • CONTACT US
  • CUSTOMER SERVIECE
  • WARRANTY STATUS
  • STORE LOCATOR
  • SITEMAP

PRIVACY & TERMS

  • TERMS OF USE
  • LEGAL TERMS
  • PRIVACY POLICY
  • TERMS & CONDITION

CONTACT US

V-CLASS MOTORSPORT (M) SDN BHD

21-1, Jalan Metro Perdana Timur 1,
Taman Usahawan Kepong, 52100 Kuala Lumpur.
Tel: 603 6258 3608
Fax: 603 6250 0838

Email : enquiry@vclassmotorsport.com

Copyright © 2019 qmaxenergysaver.com